[ROVERNET - UK] P6 rear screen seal replacement
Netspace
vmitps at netspace.net.au
Wed May 14 10:41:36 BST 2008
Put the seal in the frame (with sealer) then slide the glass in to it (more
sealer too).
PVS
----- Original Message -----
From: "peter king" <peter at king-co.com>
To: <rovernet at lyris.ccdata.com>
Sent: Wednesday, May 14, 2008 12:31 PM
Subject: [ROVERNET - UK] P6 rear screen seal replacement
> Hi all.
>
> Can anyone shed some light on the best procedure to install a new
> rear screen seal? I made a complete mess out of the job tonight, as
> the seal would not slide into the channel once the windshield was
> bedded in adhesive in it. I tried working the seal into the channel
> away from the glass, but that didn't work either. Then of course the
> adhesive started to set and that was that. A most frustrating effort.
> Tomorrow I'll try to clean the remaining adhesive off the window and
> seal and give it another try. That is, if I get some good advice!
>
> Thanks,
>
> Peter
>
>
>
>
> _______________________________________________
> Rovernet mailing list
> Rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
> instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
>
>
> --
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 269.23.15/1426 - Release Date:
> 10/05/2008 11:12 AM
>
>
More information about the Rovernet
mailing list