[ROVERNET - UK] 3500S power steering filter

[Nash4447 at cs.com]

"Bill Robertson" <rover2000nut at hotmail.com> wrote:

>I went to change the filter on the power steering and after taking off the 
>the nut and unsuccessfully trying to pull up the top, then lightly tapping 
>it up with a rubber hammer........i gave up...........is there a secret to 
>this or is it just sealed to the rubber gasket............i didn't want to 
>screw it up and finding nothing in the book about it i figured i'd ask the 
>panel here....
>
>THanks
>Bill Robertson

If this is just an Eaton pump, what you did should be all there is to it. Usually there is just a single nut or stud offset coming thru the lid. Remove it and the lid should come off.

Glenn 
>
>_________________________________________________________________
>Fine Dining & Fancy Food. Check Out This Collection Of Good Eats. 
>http://local.live.com/?mkt=en-ca/?v=2&cid=A6D6BDB4586E357F!378
>
>
>_______________________________________________
>rovernet mailing list
>rovernet at lyris.ccdata.com
>To unsubscribe, go to this web page, look near the bottom and follow instructions:
>http://mailman.nipltd.com/mailman/listinfo/rovernet
>Back-up list and photos at:
>http://autos.groups.yahoo.com/group/Rover_net/
>