[ROVERNET - UK] 1953 Rover P4 starter motor

[Paul Smith]

I have two 2000 starters with broken pinions; does anyone know a source of 
these??
I have a P4 starter in the SC now as a result.

PVS

----- Original Message ----- 
From: "Dirk" <dirk at vy-tek.com>
To: <rovernet at lyris.ccdata.com>
Sent: Saturday, September 24, 2005 9:19 AM
Subject: [ROVERNET - UK] 1953 Rover P4 starter motor


> Hi all,
>
> Well I have done it again I purchased a P4 75 1953 in California. It is a
> nice car and it was sold to me for about half of what it will cost to ship
> it from California to Mass.
> One problem though the starter motor has a broken pinion gear and I need a
> new starter. The car starts and runs with the crank but both the current
> owner and the transport company is concerned that the driver of the truck
> will have trouble. Unfortunately to keep the cost down for shipping I have
> to have the car sent to a depot in the south and then loaded on a 
> different
> truck to come up to Mass that's where the problem will occur. If anyone 
> has
> a starter that they are willing to sell me that will fit and works the
> current owner of the car has offered to change it for me.
> I can pay by a direct wire transfer to your account and you can use my UPS
> number to ship it directly to CA for me.
>
> If anyone cares to call me my cell is 978-502-2289
>
> Thanks
> Dirk
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow 
> instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet