[ROVERNET - UK] Where to find SD1 LH track control
arm orLH/RHtrack arm pair?
Kent Kinard
kkinard at swbell.net
Wed Aug 3 13:38:36 BST 2005
Hi Pierre,
Try Volvo. The CamGear rack is supposed to have the same internals as a
Volvo rack, but I don't know which model.
Roverly,
Kent K.
pj.info wrote:
> Hi Gavin
>
> I just ordered a pair from Peter van der Meulen (NL). He just advertised some
> pairs on the Net. Btw. I have a Cam Gears steering rack. Would you know where
> to get new ball joints (those directly under the rubber gaiter i.e. inside
> the steering rack)? I had to replace them with used ones some time ago.
>
> Best regards,
> Pierre.
>
> On Wednesday 27 July 2005 06:35, Gavin.Walker at csiro.au wrote:
>
>>Thanks Pierre,
>> I did a search for it and found the diagram on Rimmer's web site.
>>
>>http://www.rimmerbros.co.uk/rimmer/rover/sd1/susp-front#Steering%20Link
>>
>>Most useful.
>>
>>I've never had to replace these. As the bushes are replaceable the wear
>>point is the balljoint. Pedders, Australia, suggested that if it isn't
>>too worn they can drill a hole in the ball joint cap and inject a
>>plastic compound. Screw a grease nipple into the hole and you have a
>>good, serviceable ball joint. YMMV
>>
>>Pedders did have a spare arm but I can't remember which side it was (or
>>whether they still have them).
>>
>>Gavin Walker
>>Canberra, Australia
>>
>>
>>_______________________________________________
>>rovernet mailing list
>>rovernet at lyris.ccdata.com
>>To unsubscribe, go to this web page, look near the bottom and follow
>
> instructions:
>
>>http://mailman.nipltd.com/mailman/listinfo/rovernet
>>
>>
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
>
>
More information about the rovernet
mailing list