[ROVERNET - UK] Where to find SD1 LH track control arm
orLH/RHtrack arm pair?
pj.info
pj.info at bluewin.ch
Tue Aug 2 22:44:10 BST 2005
Hi Gavin
I just ordered a pair from Peter van der Meulen (NL). He just advertised some
pairs on the Net. Btw. I have a Cam Gears steering rack. Would you know where
to get new ball joints (those directly under the rubber gaiter i.e. inside
the steering rack)? I had to replace them with used ones some time ago.
Best regards,
Pierre.
On Wednesday 27 July 2005 06:35, Gavin.Walker at csiro.au wrote:
> Thanks Pierre,
> I did a search for it and found the diagram on Rimmer's web site.
>
> http://www.rimmerbros.co.uk/rimmer/rover/sd1/susp-front#Steering%20Link
>
> Most useful.
>
> I've never had to replace these. As the bushes are replaceable the wear
> point is the balljoint. Pedders, Australia, suggested that if it isn't
> too worn they can drill a hole in the ball joint cap and inject a
> plastic compound. Screw a grease nipple into the hole and you have a
> good, serviceable ball joint. YMMV
>
> Pedders did have a spare arm but I can't remember which side it was (or
> whether they still have them).
>
> Gavin Walker
> Canberra, Australia
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
>
>
More information about the rovernet
mailing list