[ROVERNET - UK] 2000TC rear top links

[Tom Trafton]

Bill

The bushings are press fit and can be a rather tight press fit, at that.  I
had to use a 35 ton hydraulic press to remove the old bushings and fit new.
And you will need a cylinder of a diameter that is a loose fit in the top
link bushing hole as a tool that the press can work against, i.e. something
to transfer the load from the press to the old bushing.

Tom


----- Original Message ----- 
From: "Bill Robertson" <rover2000nut at hotmail.com>
To: <rovernet at lyris.ccdata.com>
Sent: Friday, July 02, 2004 9:53 AM
Subject: [ROVERNET - UK] 2000TC rear top links


> Well i acquired a set of the bent top links and of course the big end
> bushings were shot..........and of course the bushings on my straight ones
> are both the same size..........TOO F-----N small so i,m back to square
> one..........Does anyone have a set of bent ones with good
> bushings..........Are these press fit bushings or do they somehow screw
> in...........i found a set of straight ones downstairs in my goodie box
and
> they look to have threads in the holes on the small end.........I,m also
> trying Pierre on here to get new bushings
>
> Bill Robertson
>
> _________________________________________________________________
> MSN Premium: Up to 11 personalized e-mail addresses and 2 months FREE*
>
http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
>