[ROVERNET - UK] Adhesive question.

[Eric Russell]

Ben,
All this might no apply, but......

On my hub caps, there are rivet heads which hold the
spring attachment system.  If you have those rivet
heads, you might have to prepare a smooth surface with
an epoxy such as the liquid metal variety.

You could then use contact cement to hold the decal to
the epoxy.

I would protect the decal further and add more
adhesion by spraying a clear varathane coating over
the top.

Eric

--- Ben Rodgers <irishrover at netscape.ca> wrote:

> Hi Folks
>              I have just bought a set of four centre
> decals for my TC hub 
> caps. Purchased from John Walkden via the Rover Club
> of Canada web site,I 
> was surprised to see they appear to be very thin
> material much like paper. 
> My question is = should I use a special type of
> adhesive to install them, 
> has anyone used this type of decal before and have
> advice??
>                                       Regards Ben
> (irishrover)
> 
> FREDERICK  (BEN) RODGERS.CD
> Born in Belfast, Northern Ireland,
> Author of "lily and me" a great book and a great
> read .
> Order on line at amazon
> Visit my web page  http://home.netscape.ca/~rodgl/ 
> 
> 
> 
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
> 


Webmaster of The Rover Car Club of Canada
Website:  http://www.roverclub.ca/
Webmaster of a variety of sites from:
http://www.websrus.ca


      ____________________________________________________________________________________
Never miss a thing.  Make Yahoo your home page. 
http://www.yahoo.com/r/hs