[ROVERNET - UK] 3500s water pump rebuilds

[LANCE G LACERTE, LANCE G LA CERTE]

Hi Gavin,

I was not aware of the 130-1070.  This information I pulled off of the 
Rovernet in 1998 (I just found the actual prinout).  It was sent by Bo 
Arnholm, who at the time was the webmaster for the Rover Club of Sweden. 
I'm not sure if he is still around, but if so, might be able to answer your 
question about the 1070.  As for the pulleys, once I had the output shaft 
shaved, everything lined up as with the original pump.

Lance


----- Original Message ----- 
From: <Gavin.Walker at csiro.au>
To: <rovernet at lyris.ccdata.com>
Sent: Monday, February 25, 2008 8:24 PM
Subject: RE: [ROVERNET - UK] 3500s water pump rebuilds


Hi Lance,
  Do you know if there is any difference between the 130-1420 and the
130-1070?  Did you have to do anything to make the pullies line up.
(note SD1 has a different pulley position to P6B).

Gavin Walker
Canberra, Australia



_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow 
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet
Back-up list and photos at:
http://autos.groups.yahoo.com/group/Rover_net/