[ROVERNET - UK] Mechanical Aptitude Test
Kent Kinard
kkinard at wcc.net
Sat Oct 27 22:34:09 BST 2007
I got 90. I think I missed the reciprocation question and
one of the pulley questions.
Roverly,
Kent K.
On Sat, 27 Oct 2007 12:52:21 -0700
"Slatskars" <slatskars at comcast.net> wrote:
> Don't feel bad Glen. I have been both a machinist and an
>electronics technician and I only got a 90. Yes, there
>were a few that had two possible answers. I thought that
>I would cool it. I must have blown a few of the simple
>single pulley questions.
>
> Slats
> ----- Original Message ----- From: "Glen Wilson"
><rovercar at comcast.net>
> To: <rovernet at lyris.ccdata.com>
> Sent: Friday, October 26, 2007 10:45 PM
> Subject: [ROVERNET - UK] Mechanical Aptitude Test
>
>
>> This was shared on the BMC1100 list:
>>
>> http://www.forddoctorsdts.com/quizzes/MechanicalAptitude.php
>> <http://www.forddoctorsdts.com/quizzes/MechanicalAptitude.php>
>>
>> I got an 88%. A couple of them, I goofed. A couple, I
>>had no clue. One, I
>> still barely understand. And one, was ambiguous (two
>>answers might have
>> been correct).
>>
>> Glen
>>
>>
>> _______________________________________________
>> rovernet mailing list
>> rovernet at lyris.ccdata.com
>> To unsubscribe, go to this web page, look near the
>>bottom and follow
>> instructions:
>> http://mailman.nipltd.com/mailman/listinfo/rovernet
>> Back-up list and photos at:
>> http://autos.groups.yahoo.com/group/Rover_net/
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
>bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
More information about the rovernet
mailing list