[ROVERNET - UK] Rust proofing a P6

[James Dean]

Since all the body panels unbolt easily; remove them, clean inspect, and if 
surface rust is found, treat it with Ospho, or other anti-rust compound. 
Prime with a spray can phosphate primer, or Rustoleum hammered paint,, then 
undercoat with a good paintable undercoat; as 3M or body schutz. reinstall 
with stainless steel fasteners.  Similar procedure under the floor.Or, just 
buy my rust free 2000TC, that had that done, and more. James Dean, Ft. 
Lauderdale  jaguru at bellsouth.net
----- Original Message ----- 
From: "phing" <phing at videotron.ca>
To: <rovernet at lyris.ccdata.com>
Sent: Wednesday, November 07, 2007 8:13 PM
Subject: [ROVERNET - UK] Rust proofing a P6


> Hi
> Any advice on how and where to rustproof a P6 ?? My new toy Rip Van Winkle 
> is rust free . I would like to have it rustproofed but have no idea where 
> to drill holes , or what to use  for best results . Any advice would be 
> gratefully received .
> RVw is currently black with elegant real paint [ not tape] gold 
> pinstriping . Black was not a standard P6 color , the Heritage cert says 
> it was Arden green . There is no green to be found any where , the engine 
> bay is black with all the correct stickers and transfers in place . So has 
> RVW had a super respray or was it a special order ?? I'm not convinced the 
> Heritage cert is correct , they claimed my P3 was originally grey , when 
> we stripped it back to bare metal we found it was black all the way down 
> to the original Rover red undercoat .
> Cheers
> Patrick
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow 
> instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/