[ROVERNET - UK] P6 - Query re fitting new seal to rear boot deck
Paul Smith
Paul.Smith at auroraenergy.com.au
Wed Nov 1 21:20:39 GMT 2006
I should be able to photograph mine tonight and send them through.
PVS
-----Original Message-----
From: rovernet-bounces at lyris.ccdata.com
[mailto:rovernet-bounces at lyris.ccdata.com]On Behalf Of Peter Mitchell
Sent: Wednesday, 1 November 2006 9:19 pm
To: rovernet at lyris.ccdata.com
Subject: [ROVERNET - UK] P6 - Query re fitting new seal to rear boot
deck
Hi Netters,
I am in the process of replacing the rear boot deck seal on my P6B. I have
the rear decker panel out on a table with the seal pushed into place ready
to be secured by the curved pieces of metal frame.
My query is: The seal as supplied is a bit too long. Before I do any
cutting, could anyone with a P6 please advise:
Is the deck seal simply cut off square at the end, or is there a chamfer?
I've been going through my photographs to see if I have one for comparison,
but no luck so far.
(As you can see, the purchase of a workshop manual is imminent).
I'd be grateful for advise and possibly even a photo of a seal in place if
it is not too much trouble.
Once again I must say that I'd have given up on my restoration without
Rovernet.
Kind regards
Peter Mitchell
Perth Western Australia
_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet
Back-up list and photos at:
http://autos.groups.yahoo.com/group/Rover_net/
More information about the rovernet
mailing list