[ROVERNET - UK] uns*bscribe
Andrew H. Litkowiak
andylit at runbox.com
Sun May 14 14:36:55 BST 2006
Peter Mitchell wrote:
> Hi Eric,
>
> I am going off the net for a week or two for pc repair / upgrade, please
> unsubscribe me for the present.
>
> Kind regards
Here is how to unsubscribe:
First, e-mail rovernet-request and ask for an Unsubscribing Kit. Then follow
these simple directions.
The kit is the standard no-fault type. Depending on requirements, System A
and/or System B can be used. When operating System A, depress lever and a
plastic dalkron unsubscriber will be dispensed through the slot immediately
underneath. When you have fastened the adhesive lip, attach connection marked by
the large "X" outlet hose. Twist the silver- colored ring one inch below the
connection point until you feel it lock.
The kit is now ready for use. The unsubscriber is activated by the small switch
on the lip. When securing, twist the ring back to its initial condition, so that
the two orange lines meet. Disconnect. Place the dalkron unsubscriber in the
vacuum receptacle to the rear. Activate by pressing the blue button.
The controls for System B are located on the opposite side. The red release
switch places the unsubscriber into position; it can be adjusted manually up or
down by pressing the blue manual release button. The opening is self-adjusting.
To secure after use, press the green button, which simultaneously activates the
evaporator and returns the unsubscriber to its storage position.
You may log off if the green exit light is on over the evaporator. If the red
light is illuminated, one of the unsubscriber requirements has not been properly
implemented. Press the "List Admin" call button on the right of the evaporator.
I will secure all facilities from my control panel.
To use the Auto-Unsub, first undress and place all your clothes in the clothes
rack. Put on the Velcro slippers located in the cabinet immediately below. Enter
the Con-tainer, taking the entire kit with you. On the control panel to your
upper right upon entering you will see a "Con-tainer seal" button. Press to
activate. A green light will then be illuminated immediately below. On the
intensity knob, select the desired setting. Now depress the Auto-Unsub
activation lever. Act normally.
The Auto-Unsub will automatically go off after three minutes unless you activate
the "Manual off" override switch by flipping it up. When you are ready to leave,
press the blue "Con-tainer seal" release button. The door will open and you may
leave. Please remove the Velcro slippers and place them in their receptacle.
If you prefer the ultrasonic log-off mode, press the indicated blue button. When
the twin panels open, pull forward by rings A & B. The knob to the left, just
below the blue light, has three settings, low, medium or high. For normal use,
the medium setting is suggested. After these settings have been made, you can
activate the device by switching to the "ON" position the clearly marked red
switch. If during the Unsubscribing operation, you wish to change the settings,
place the "manual off" override switch in the "OFF" position. You may now make
the change and repeat the cycle. When the green exit light goes on, you may log
off and have lunch. Please close the door behind you. Don't forget to dressb
efore leaving the room.
More information about the rovernet
mailing list