[ROVERNET - UK] SD1 Alloys on P6B - tight fit on the front wheels
James Dean
jaguru at bellsouth.net
Fri Sep 30 17:08:38 BST 2005
I forwarded the question on SD1 wheels to Randy in Miami
((noblious at aol.com). He is running SD1 wheels on his Federal 3500S. < as
sometimes he cannot post. James Dean, Ft. Lauderdale.
----- Original Message -----
From: "Peter Mitchell" <peterm at arach.net.au>
To: <rovernet at lyris.ccdata.com>
Sent: Friday, September 30, 2005 7:48 PM
Subject: [ROVERNET - UK] SD1 Alloys on P6B - tight fit on the front wheels
> Hello Rovernetters
>
> I have had a freshly powedercoated set of SD1 alloys fitted to my P6B.
> They
> are light grey and look stunning. The only problem is that they are a
> tight
> fit over the caps that cover the front wheel bearings. In fact the caps
> have
> prevented the wheels from completely centering [maybe 1-1.5 mm off centre]
> and I have some wheel shudder. My tyre man is going to look at the wheels
> again in the morning, and we have discussed two possible solutions:
>
> [1] File the edge of the bearing caps to reduce the size of the flange
> that
> sticks out to impede the wheel going on.
>
> [2] Have a machine shop take a tiny amount out of the centre of the new
> alloys.
>
> Has any other intrepid P6 owner with SD1 wheels had this experience? I
> would value input. [This is the inscrutable Australian way of saying
> "help"].
>
> Kind regards
>
> Peter Mitchell
> Perth WA [That's Western Australia]
> Rover P6B
>
>
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
> instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
>
More information about the rovernet
mailing list