[ROVERNET - UK] P6 tach

Eric Russell p6rovers at yahoo.com
Thu May 26 16:58:06 BST 2005

Yes. I used that screw to match my Tach to the
external Tach I used.  (At least I felt better that
they both agreed.) It seemed to help when I was making
adjustments under the hood/bonnet and didn't have to
go back and look at the dash.


--- Larry <lewill at ctcweb.net> wrote:
> To the group,
>     Has anyone recalibrated a P6 tach? I thought
> that the engine was revving
> much lower than the tach indicated. I attached an
> external tach and there
> was a 600rpm difference. There is a port? on the
> back of the tach that has a
> rubber grommet and if you remove it there is a
> plastic slotted screw head.
> Is this the screw that you turn? Regards, Larry
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet

Webmaster & Magazine Editor:
The Rover Car Club of Canada -  www.roverclub.ca

Yahoo! Mail Mobile 
Take Yahoo! Mail with you! Check email on your mobile phone. 

More information about the rovernet mailing list