[ROVERNET - UK] Clickety Clat
Paul Smith
vmi2148 at bigpond.net.au
Sun Mar 27 11:31:26 BST 2005
Sounds like lack of oil - check the 3 bolt plate at the back of the
camshaft, if it isn't tight the oil doesn't feed through the cam. Noise
plus, I found out...
PVS
----- Original Message -----
From: "Nottingham Road Giftware" <sales at nottinghamroad.com>
To: <rovernet at lyris.ccdata.com>
Sent: Sunday, March 27, 2005 8:02 PM
Subject: [ROVERNET - UK] Clickety Clat
> Hello All.
>
> I just replaced the head on my TC -- Ground valves/new seats etc. and
> there is too much valve clatter. The tappet clearances are very close to
> spec, with most right-on (within .002 off-spec worst case). Valve springs
> are good. Oil ways are clear to all cam bearings etc. The car runs great,
> but the noise is getting on my nerves. I have had valve clearances way
> off in the past and they did not make much noise. It does not seem like
> one valve, but it is equal amongst all of them. Anybody have the same
> problem? Should I ignore it and keep on motoring?
>
> Steve Lawrence
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
> instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
More information about the rovernet
mailing list