[ROVERNET - UK] New Rover 75 V8 Engine Bay

[Ian Gilleran]

Do I spy a sub frame holding the radiator onto the engine assembly.
Has the designer been reading the P5 Parts Manual?

I should imagine there would be a lot of insulation required on the engine
bulkhead to deflect the heat from the silencers. Is it must be a stainless
steel item?
If  a mild steel exhaust ,would the engine have to come out when replacing
the silencers shown ?

Cheers

Ian Gilleran

----- Original Message ----- 
From: "Peter Huttemeier" <peterhut at melbpc.org.au>
To: <rovernet at lyris.ccdata.com>
Sent: Tuesday, August 17, 2004 4:16 PM
Subject: Re: [ROVERNET - UK] New Rover 75 V8 Engine Bay


> See engine pics here:
>
> http://member.melbpc.org.au/~peterhut/mgroverpics.htm
>
>
> Cheers,
>
> Peter H
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet